Proper

Abstract

As we all are aware of the fact that there exist Thermodynamic laws which are responsible for any motion of heat in this universe. There are three basic laws governing the motion of heat .In which the first law of Thermodynamics states that “Energy can neither be created nor destroyed but can only be converted from one form to another” and the second law’s statements can be boiled down to “It is impossible to construct any device or engine that operates in a cycle and produces no effect other than transfer of heat from a reservoir at lower temperature to another reservoir at higher temperature ,without external work being done on it” i.e. conversion of total input energy to work done is impossible. So this paper proposes the possibility of the existence of a machine which takes negligible amount of energy as Input and produces Energy as output having magnitude next to infinity(tending to infinity). Such a machine should be known as “Perpetual Motion Machine 2” because of its relevance with the Second Law of Thermodynamics but as the long standing books call it to be impossible , so to give scope to this topic the name “Perpetual Motion Machine 3” would be appropriate .
There are four gears forming a train where one gear is connected to the external source which gives it the initial start .Hence it takes very little input from the battery then it is switched off .This is enough to make it rotate and its rotation causes other gears to rotate in order of their sequence .These gears cause the coils of the dynamos to rotate .These dynamos are connected to the gears so when the gears rotate they cause the dynamos to rotate .The rotation of the dynamos causes them to generate AC to flow in the circuit represented in given figure .This AC generated in the circuit is transferred to the Step-Up Transformer which increases the voltage of the incoming, generated AC. This amplified AC is then put in the Bridge Full Wave Rectifier where the AC gets converted to DC and is even amplified due to the inbuilt property of Bridge Full Wave Rectifier .Then this DC current is divided into (n+1) parts ,where n is the number of loads connected in the circuit which have to be supplied with electricity as a result of generation of the current in this machine ,then that last part is then given back to the initial gear which was causing them to rotate then the cycle has been completed then the initial supply is switched of causing the initial gear to run on the energy as a result of its own generation. Work done due to any generation of power as a result of the work it did due to input from the battery is again causing it to rotate .Hence making a complete cycle .